Bauer 1966E-B Owner's Manual & Safety Instructions page 15

Grinding, and Wire Brushing Instructions
TO PREVENT SERIOUS INJURY: Grip the tool firmly in both hands.
1. Make sure that the Paddle Switch is in
the off-position, then plug in the tool.
2. Place one hand on the motor housing the other
on the side handle before starting the tool.
3. Start the tool by pulling the Paddle Lock
back and squeezing the Paddle Switch.
Sanding Instructions
TO PREVENT SERIOUS INJURY: Grip the tool firmly in both hands.
1. Wipe the work surface clean of all dirt and debris,
especially that of previous
coarser sanding sessions, which will scratch
the surface of a finer grit sanding session.
2. Attach the desired grit Sanding Disk
(sold separately) onto the Spindle.
3. Make sure that the Paddle Switch the
off-position, then plug in the tool.
4. Start the tool by pulling the Paddle Lock
back and squeezing the Paddle Switch.
5. Wait until the tool has reached full speed,
then gently contact the surface.
Item 57002
Paddle Lock
For technical questions, please call 1-888-866-5797.
4. Allow the tool to come up to full speed
before touching the work material.
5. Apply the wheel to the work material at a 10° – 15°
angle, allowing the tool to operate at full speed.
If the tool bogs down, use lighter pressure.
6. To create a smoother surface,
keep the tool moving over the work surface.
7. TO PREVENT ACCIDENTS, AFTER USE:
Turn off the tool by releasing the Paddle Switch.
WARNING! Allow the tool to come to a complete
stop before setting it down.
Unplug the tool. Clean, then store the
tool indoors out of children's reach.
6. Keep heavy pressure off of the tool when operating.
Allow the tool to do the work.
7. Move the tool in a uniform pattern up and down or
side to side while sanding to ensure even sanding.
8. Periodically, stop the tool by releasing the Paddle
Switch and check for disc wear.
Replace worn sanding discs as needed.
9. TO PREVENT ACCIDENTS, AFTER USE:
Turn off the tool by releasing the Paddle Switch.
WARNING! Allow the tool to come to a complete
stop before setting it down.
Unplug the tool. Clean, then store the
tool indoors out of children's reach.
Page 15