Bauer 1966E-B Owner's Manual & Safety Instructions page 13

Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Paddle Switch is in the off-position and unplug the tool from
its electrical outlet before performing any procedure in this section.
Installing a Non-threaded Grinding Wheel
1. The Grinding Wheel MUST be:
• rated to at least 11,500min.
• no larger than 4-1/2" (115mm) in diameter.
• fitted with a 5/8" - 11 UNC round arbor hole.
• 1/4" (6mm) thick or less.
• suitable for surface grinding, not edge grinding.
• dry and clean.
• proven undamaged by inspection.
2. Press in and hold the Spindle Lock Button
to prevent the Spindle from turning.
3. Remove the Outer Flange.
Keep the Inner Flange in position on the Spindle
Installing a Threaded Accessory
TO PREVENT INJURY: Wear heavy-duty work gloves when handling wire wheels and brushes.
These accessories are sharp and can cause injury.
1. The accessory MUST be:
• rated to at least 11,500/min.
• no larger than 4-1/2" (115mm) in diameter.
• fitted with a threaded opening of 5/8" - 11 UNC.
• undamaged.
• a sanding disc and backing pad, or
a sanding flap disc; a wire wheel, or
a wire cup brush; (accessories not included).
Item 57002 For technical questions, please call 1-888-866-5797.
Spindle
Lock Button
Spindle
Inner
Flange
4. Thread the Outer Flange onto the Spindle.
Wrench tighten only enough so that the wheel is
securely held on the spindle.
WARNING: To prevent serious injury,
do not overtighten flange. Overtightening can
damage the wheel, causing wheel failure.
2. Press in and hold the Spindle Lock Button
to prevent the Spindle from turning.
3. Remove the Outer Flange and Inner
Flange, and keep in a safe place.
4. Thread disc accessory onto the Spindle.
Wrench tighten onto the Spindle.
Grinding Disc
Outer Flange
Wrench
Page 13