Advertisement
Assembly Procedure
1.
Set up the tripod base:
a.
Set the base on the floor, resting on its casters.
b.
Press down on the slide yoke ring. Hold the ring down while you swing the two
forward legs out until the yoke ring snaps back place into the locking hole on
the bottom of the slide tube (see Figure 1).
c.
To prevent the tripod base from rolling backwards during assembly, lower the
backstop as shown.
Press down on slide yoke ring
Set (lower) the Backstop
2.
Set the frame assembly onto the two "V" angles on the tripod base and lower the
frame about 1 inch. until it is secured by the angles.
Before continuing, be sure the frame is pushed down and is held securely by the
angles.
Cradle
Telescoping
Sections
Housing
Winch
Tripod Base
Components
Crossarm
Frame Assembly
Advertisement
