Table of Contents
Advertisement
PRESS
Slide the Liquid insert inside the shield assembly and ensure it is attached firmly.
Make sure the valve is secure.
Ensure insert is flush with shield. Place seal diaphragm on the shield assembly. Tip
- use your finger to ensure the edge is flush. This is important so the kit is airtight.
Attach your seal cap & then use your tubing to connect your accessory kit to the
pump motor. Don't forget to cover the unused air port if you're single pumping!
12
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the GENIE ADVANCED and is the answer not in the manual?
Questions and answers