Makita SK700D Manual page 194

Accuracy Check
Perpendicularity horizontal
intersection points
Place lock switch in "Unlocked" position (see
elling lock). Mark a reference point (P1) approx.
5m from the walls and position the lower plumb
intersection point exactly on it. Align the cross hair
to the left wall and mark the intersection point (a1)
approx. on the same hight like P1 to the wall.
Shortly after mark the right-hand perpendicular
beam (b1) on the front wall.
Makita SK700D/SK700GD
Lev-
Then rotate the instrument exactly 90° clockwise
around the plumb intersection point P1 and pos-
ition the left-hand perpendicular intersection
beam to the existing reference point a1. Make
sure that the lower plumb intersection point is still
exactly on the reference P1. Check afterwards the
new reference point b2 with the old reference b1
on the front wall. The deviation between the two
points may be max. 3mm. Mark the new position
of the right-hand perpendicular beam to the right
wall with c1.
Should your instrument be outside of the spe-
cified tolerance, please contact a local dealer
or an authorised Makita distributor.
Afterwards, turn the instrument exactly 180°
around the plumb intersection point P1 and pos-
ition the right-hand perpendicular beam to the
existing reference point a1. Make sure that the
lower intersection plumb point is still exactly on the
reference P1. Then mark the left-hand beam to
the right wall and mark it with c2. Finally measure
the difference between the former reference point
c1 and the new point c2. The deviation may be
max. 3mm between these two points.
Should your instrument be outside of the spe-
cified tolerance, please contact a local dealer
or an authorised Makita distributor.
18