Summary of Contents for Lakes Bathrooms Curved Corner
Page 1
Ø3.5mm SHOWER TRAY INSTRUCTION Curved Corner Shower Tray Helpline : 01684 853870 www.lakesbathrooms.co.uk ON FLOOR INSTALLATION Remove protective plastic film from the areas near the Ensure that the location of the shower tray is firm, level, waste and those sides of the tray which will be against a and clean.
Page 2
ON FLOOR INSTALLATION Place shower tray in position with tray edges upto & Level the tray and allow to set. parallel to walls. Apply gentle pressure with the palms of the hands & small side to side motions to ensure tray is fully supported on it's bed.
RAISED INSTALLATION - Panel Pack 5 Parts Supplied: M4*14mm Leg fixing hole (non reinforced): Drill Ø3.5 x 5mm MAX deep. Ø3.5mm Turn the tray over and use the cardboard packaging as a protective mat. Note the circles that have been marked to Reinforced Area : indicate feet position.
RAISED INSTALLATION Turn tray over & fit waste. Place in position, edges upto & parallel to walls. Adjust legs at rim & level tray in both directions; maintain 100mm nominal panel gap & ensure ALL legs are in firm When shower tray is set remove the remainder of the contact with floor &...
SHOWER TRAY INSTRUCTION Care & Maintenance Providing this shower tray has been installed correctly, difficulties should not be encountered. If however, maintenance is required it should be carried out by a suitably qualified person. Cleaning : It is advised that the shower tray be cleaned regularly to reduce build up of deposits (limescale etc).