Related Manuals for Lakes Bathrooms SS120S
Summary of Contents for Lakes Bathrooms SS120S
- Page 1 SS120 Hinged Panel Bathscreen Installation & Maintenance instructions Rev. 09.16 Lakes Bathrooms...
-
Page 2: Important Notes
Before any work is carried out the root cause of the problem must be identified. Lakes Bathrooms service engineers are available if necessary to consult / carry out remedial work. Call Lakes Bathrooms HELPLINE. Cleaning. -
Page 3: Customer Service
Customer Service. Quality Guarantee : Lakes Bathrooms Ltd guarantee Shower Doors & Enclosures against any manufacturing or material defects for the lifetime of the product. We will resolve defects free of charge by repairing / replacing parts as we feel necessary. To be ‘free of charge’ service work must be carried out by Lakes Bathrooms or approved agents. -
Page 4: Parts Supplied
Parts supplied: 1x Top Plug 1x Bottom Plug 2x Glazing Gasket 1x Fixed Panel 1x Hinge Panel 2x Hinge Washer 2x Seal End Cap (Handed Pair) 3x Wall Plug 3x 60mm M5 Screw 1x Wall Profile 4x 30mm M4 screw 3x 10mm M3.5 Screw, Washer &... -
Page 5: Tools Required
Tools Required: Spirit level with Power drill with 8mm Good quality silicone sealant and applicator Pencil Pozidriv Screwdriver Tape measure 3mm HSS drill bit Lakes fully reversible hinged panel bathscreen for fitting left or right handed to suitable bathtub. Ensure bath rim is level &... - Page 6 It is important to assess the fall of the bath rim and position the wall profile so that any water runs off into the bath and does not pool on the bath rim With the curved face of the wall profile facing outwards, use the spirit level to ensure wall profile is plumb, mark screw holes then drill the wall with the 8mm masonry bit, plug and...
- Page 7 1. Fit the hinge seal into the groove on the hinge profile. 2. Slide the fixed panel assembly into the wall profile and position so that the bottom of the panel sits on the rim of the bathtub & is plumb. Using the wall profile holes as a guide, drill the 3mm holes and then secure the fixed panel using the 10mm M3.5 screws and washers then push on the cover caps.
- Page 8 Loosen clamping screw then place bracing arm on glass as shown. Position arm so that the wall end sits flush with the wall the mark the hole position, drill (8mm), plug & affix to wall using 5mm x 60mm screw. Ensuring the gasket is in position in the bracing arm, tighten the clamping screw.
- Page 9 Use of good quality silicone sealant & cleaning / degreasing of all joint areas is recommended. Apply continuous silicone sealant bead as indicated EXTERNALLY ONLY...
-
Page 10: Basic Troubleshooting
ONLY. Water / moisture appearing outside this area (ie at floor level, or under bathtub) is normally due to incorrect bathtub / screen sealing. Lakes Bathrooms Ltd Service : Northern Ireland Alexandra Way...