Table of Contents
Advertisement
4. Route remote socket wiring forward through
firewall accessory grommet
prevents contact with hot components, sharp
edges, or moving parts.
Connect wires as follows:
• ORANGE wire: To terminal block post with
existing ORANGE wire (accessory switched 12V
POS)
• BLACK wire: To mating connector from
t
contactor
.
5. Torque nut on terminal block (orange wire post) to
specification.
TORQUE
20–25 in. lbs. (2.3–2.8 Nm )
6. Secure winch socket harness using cable ties
to prevent contact with hot components, sharp
edges, or moving parts.
K
. Ensure routing
s
Instr 9926739
Rev 02 2018-09
FINAL INSTALLATION
1. Carefully examine all harness routing. Ensure
harnesses are routed and secured to prevent
contact with hot components, sharp edges, or
moving parts. Use cable ties
2. Restore access. See beginning of procedure.
3. Reconnect black negative (-) cable to battery, then
reinstall storage compartment and seats.
4. Connect remote switch
5. Retighten all hardware after 30 minutes of riding.
Page 7 of 9
s
as required.
y
o
to remote socket
.
Advertisement
Table of Contents
