Table of Contents
Advertisement
3. Install mounting plate
follows:
a. Upper holes: two screws
FRONT to REAR. No nuts are needed.
b. Lower holes: two screws
REAR to FRONT, secured with nuts
Torque screws to specification.
TORQUE
25 ft. lbs. (34 Nm) ± 10%
4. Install winch cables.
a. Loosely install 800 mm yellow cable
f
blue cable
to corresponding color posts on
winch.
a
(with winch) to vehicle as
2@
installed from
k
installed from
1(
.
d
and
Instr 9926739
b. Route opposite end of cables up through
under-hood liner towards contactor. Ensure
routing prevents contact with hot components,
sharp edges, or moving parts (including
suspension and steering components
throughout their full range of travel).
c. Loosely install yellow winch cable
winch cable
contactor.
d. Tighten nuts on contactor AND winch (yellow
and blue wire posts), then install terminal
boots.
e. Secure winch cables to main chassis harness
and chassis structure using cable ties
prevent contact with hot components, sharp
edges, or moving parts.
Rev 02 2018-09
Page 5 of 9
d
f
to corresponding color posts on
and blue
s
to
Advertisement
Table of Contents
