Table of Contents
Advertisement
5. Route winch cable through roller fairlead
install fairlead to front bumper using two each
g
screws
and nuts
REAR to FRONT.
6. Reinstall front bumper with retained fasteners. See
previous Step 1.
w
7. Attach hook
to loop at end of cable
secure using cotter pin.
REMOTE SOCKET INSTALLATION
IMPORTANT
Verify opposite side of wall is free from structure,
components, wiring, lines, ducts, etc.
1. Drill holes in dash panel as follows:
a. 1–1/16 inch (27 mm) hole
two fastener dimples
b. Two 1/4 inch (6 mm) holes at dimples
e
1(
. Screws are installed from
r
, then
G
centered between
F
F
Instr 9926739
, then
2. Feed wiring on remote socket
then install socket to dash panel using two each
j
screws
washers beneath nuts (not screw heads).
3. If firewall accessory grommet is already installed,
then proceed to next step.
Otherwise, cut 1–11/16 inch (43 mm) hole at
location
accessory grommet (PN 5414440, sold
separately).
Rev 02 2018-09
Page 6 of 9
o
2!
, washers
, and nuts
H
(behind washer bottle
through hole,
2)
. Install
J
), then install
Advertisement
Table of Contents
