Table of Contents
Advertisement
1.
Before attaching the adapter, look through your spotting scope,
and make sure that the view is in sharp focus.
2.
Open the
eyepiece clamp
(B) by loosening the
knob
(A) at the top of the eyepiece clamp.
3.
Place the eyepiece clamp over the eyepiece of your
scope. Tighten the eyepiece clamp knob to secure the
eyepiece clamp tightly against the
NOTE:
Make sure to mount the clamp on a section of the
eyepiece barrel that does not rotate freely, such
as the magnification zoom adjustment dial.
4.
Loosen the
holder clamp knob (D)
open wide enough to accommodate the width of your phone.
Once the phone is in place, tighten the holder clamp knob until
the phone is secured.
NOTE:
This adapter can be used with most phone cases,
but the case surface MUST be flat so it will fit in the
holder correctly. Any grips, stands, rings, or raised
surfaces on the case will impede the placement of the
phone. All folio-style phone cases must be removed.
5.
eyepiece clamp
6.
eyepiece.
7.
8.
until the
holder clamp
(C) is
IMPORTANT:
sufficently loosened before attempting to remove the adapter from
the scope eyepiece
CAUTION: Do not carry the scope with the smartphone adapter
Launch the camera app on your phone. Loosen the
alignment knob (E)
and adjust the positioning of your
phone camera so that it lines up with the eyepiece of your
optic.
Once the camera is over the eyepiece and your camera is
capturing the view through the eyepiece, carefully tighten the
holder alignment knob to secure your phone in position.
If needed, adjust the focus on your scope again for the
sharpest possible view.
You are now ready to take images and videos using your
smartphone camera!
always be certain the eyepiece clamp knob is
in place as it may be accidentally bumped and fall off,
potentially damaging the smartphone as a result.
holder
7
ENGLISH I
Advertisement
Table of Contents
