Related Manuals for IDS Ezi4
Summary of Contents for IDS Ezi4
- Page 1 IDS Ezi4 Alarm Panel Installer Manual SOUTH AFRICA’S LEADING MANUFACTURER AND DISTRIBUTOR OF ELECTRONIC SECURITY PRODUCTS...
- Page 2 Ezi4 Alarm Panel 700-497-02A Issued April 2012 Introducing the Ezi4 Alarm Panel Thank you for purchasing an Ezi4 Alarm Panel. The Ezi4 Alarm Panel is built to the same robust standards that apply to all IDS products. We wish you years of problem free security.
-
Page 3: Installation And Wiring
Figure 1: Ezi4 Connection Diagram Power Supply The Ezi4 Alarm panel has a single linear regulator onboard that both charges a battery and supplies power to auxiliary power supply terminals. 91 Escom Road • New Germany • 3610 • South Africa • P O Box 738 • New Germany • 3620 • South Africa Tel: +27 (0)31 705 1373 •... - Page 4 Black (Negative) battery leads on the panel as shown. The panel is polarity protected via a 1A ‘fastblow’ fuse The auxiliary power supply on the Ezi4 alarm panel is used to supply power to any peripheral hardware (passive infra-red detectors, remote receivers etc) that connects to the panel.
- Page 5 Ezi4 Alarm Panel 700-497-02A Issued April 2012 End of line terminating resistors must be used for the Arm/Disarm Zones (labelled “ARM” on the Panel) as well as the four Alarm Zones (labelled “1”, “2”, “3”and “4”on the panel) even if a zone is unused. Failure to do so will result in the zone showing a violated state, which will prevent the panel from arming.
- Page 6 When a new Alarm condition is generated, PGM 2 will turn on momentarily for 1 second. This output is designed to link the Ezi4 Alarm Panel to either a communicator input or to link the Ezi4 Alarm Panel to another panel.
- Page 7 Arming the Panel The Ezi4 alarm panel will enter the armed state if the arm zone is violated whilst all four alarm zones are un-violated and the tamper input is closed. The siren will sound a single beep for 1 second (toot on arm) and PGM1 will illuminate.
-
Page 8: Warranty
NOTE: Wherever possible, return only the PCB to Inhep Electronics Holdings service centres. DO NOT return the enclosure. The IDS Ezi4 Alarm Panel is a product of IDS (Inhep Digital Security) and is manufactured by Inhep Electronics Holdings (Pty) Ltd...