Dell Inspiron 13 5310 Service Manual page 39

Steps
1. Place the display assembly on a clean and flat surface with the display panel facing up.
2. Place the palm-rest and keyboard assembly under the display hinges.
CAUTION: To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display
assembly.
3. Close the left-display hinge and align the screw holes on the left-display hinge with the screw holes on the palm-rest and
keyboard assembly.
4. Replace the screw (M2x3) that secures the left-display hinge to the palm-rest and keyboard assembly.
5. Replace the screw (M2x4) that secures the left-display hinge to the palm-rest and keyboard assembly.
6. Close the right-display hinge and align the screw holes on the right-display hinge with the screw holes on the system board.
7. Place the Type-C port-bracket on the palm-rest and keyboard assembly.
8. Align the screw holes on the Type-C port-bracket to the screw holes on the right-display hinge.
9. Replace the two screws (M2x4) that secure the Type-C port-bracket to the palm-rest and keyboard assembly.
10. Connect the display cable to the connector on the system board and close the latch.
11. Adhere the tape that secures the display-cable connector latch to the system board.
12. Place the display-cable bracket over the display-cable connector.
13. Align the screw hole on the display-cable bracket to the screw hole on the system board.
Removing and installing components 39