Redback E137C Operation Manual page 6

for outdoor use. Use of a cord suitable
for outdoor use reduces the risk of
electric shock.
6. If operating a power tool in a damp
location is unavoidable, use a residual
current device (RCD) protected supply.
Use of an RCD reduces the risk of
electric shock.
Personal Safety
1. Stay alert, watch what you are doing
and use common sense when operating
a power tool. Do not use a power tool
while you are tired or under the
influence of drugs, alcohol, or
medication. A moment of inattention
while operating power tools may result
in serious personal injury.
2. Use personal protective
equipment. Always wear eye
protection. Protective equipment such
as dust mask, non-skid safety shoes,
hard hat, or hearing protection used for
appropriate conditions will reduce the
risk of injury.
3. Prevent unintentional starting. Ensure
the switch is in the off-position before
connecting to the power source and/or
battery pack, picking up, or carrying the
tool. Carrying power tools with your
finger on the switch or power tools that
have been turned on invites accidents.
4. Remove any adjusting key or wrench
before turning the power tool on. A
5
wrench or a key left attached to a
rotating part of the power tool may
increase the risk of injury.
5. Do not overreach. Keep proper
footing and balance at all times. This
enables better control of the power tool
in unexpected situations.
6. Dress properly. Do not wear loose
clothing or jewelry. Keep your hair,
clothing and gloves away from moving
parts. Loose clothes, jewelry or long hair
can be caught by moving parts.
7. If devices are provided for the
connection of dust extraction and
collection facilities, ensure that these
are connected and properly used. Use
of dust collection can reduce dust-
related hazards.
Power Tool Use And Care
1. Do not force the power tool. Use the
correct power tool for your application.
The correct power tool will do the job
better and safer at the rate for which it is
designed.
2. Do not use the power tool if it can't be
turned on and off by its switch. Any
power tool that cannot be controlled with
the switch is dangerous and must be
repaired.
3. Disconnect the plug from the power
source and/or the battery pack from the
power tool before making any
adjustments, changing accessories, or