Redback E137C Operation Manual page 10

Inserting/Replacing The
Battery
Ensure that the battery is fully charged
before inserting it into the tool.
1. Open the battery cover.
2. Press the charged battery into the
power tool until it clicks into place.
3. Close the battery cover.
Removing the Battery
1. Press the release button.
2. Pull out the battery.
GENERAL SAFETY
WARNING #4!
9
Switching The Power Tool
On
1. Press the switch interlock and hold
down (see #1 in the illustration
below).
2. Pull back On/Off switch towards the
handle (see #2 in the illustration
below).
3. The motor runs.
Switching The Power Tool
Off
1. Release the On /Off switch (see #2
in the illustration above).
GENERAL SAFETY
WARNING #1!
Removing And Emptying
The Grass Catcher
1. If the grass catcher bag is full and
should be emptied immediately.
2. Switch the motor off.
3. Wait until the cutter bar stops.
4. Lift the discharge flap.
5. Remove the grass catcher.
6. Lower the discharge flap down
again.