Adjusting Oven Temperature; Fan Blade - Frigidaire FEB27T6CSA Service Data Sheet

ADJUSTING OVEN TEMPERATURE

1. Push the BAKE pad.
2. Set the temperature to 550°F/288°C by pushing the UP arrow pad.
3. Within 2 seconds, push and hold the BAKE pad for approximately 5 seconds until the special 2
digit display appears. Release the BAKE pad.
The display now indicates the difference in degrees between the original factory temperature
setting and the current temperature setting. If the oven control has the original factory calibration,
the display will read "00".
4. The temperature can now be adjusted up or down 35°F/17°C, in 5°F/2.5°C increments, by pushing
the UP or Down arrow pads. Adjust the UP/DOWN arrow pads until the desired amount of offset
appears in the display. A minus sign (-) will appear before the number to indicate the oven will be
cooler by the displayed amount of degrees.
5. When you have made the desired adjustment, push the CANCEL pad to go back to the time of
day display.
NOTE: CHANGING CALIBRATION EFFECTS BOTH CONVENTIONAL AND CONVECTION MODES.

FAN BLADE

The fan blade is mounted in the rear of the unit and has a "D" shaped opening. Only minimum clearance
exists between the oven back, fan blade, and fan shroud. Be careful not to bend blade when removing
or installing.
Access to the fan blade is gained by removing the fan shroud, held in place by three screws, from the
inside of the oven.
The fan blade is held in place with a hex nut that has left handed threads. When
removing this nut, gently hold the fan blade, and turn the nut clockwise. If one of the
blades becomes deformed, it may be bent back into shape using a flat surface as a
reference.
NOTE: IF THE FAN BLADE IS BENT AND MOTOR VIBRATIONS
INCREASE, THE NOISE MADE BY THE FAN WILL BE
GREATER.
8