Adjusting The Handle Position - Makita DUX18 Instruction Manual

Mounting the attachment pipe
CAUTION:
Always check that the attachment
pipe is secured after installation. Improper instal-
lation may cause the attachment falling off from the
power unit and cause personal injury.
Mount the attachment pipe to the power unit.
1.
Turn the lever of the power unit toward the attach-
ment side.
► 1 . Lever
2. Remove the cap of the attachment. Align the pin
with the arrow mark and insert the attachment pipe until
the release button pops up.
► 1 . Release button 2. Arrow mark 3. Pin
3.
Turn the lever toward the power unit side.
► 1 . Lever
1
1
2
3
1
Make sure that the surface of the lever is parallel to the
pipe.
To remove the pipe, turn the lever toward the attach-
ment side and pull the pipe out while pressing down the
release button.
Fig.12
► 1 . Release button 2. Lever 3. Pipe

Adjusting the handle position

Adjust the handle position to obtain comfortable han-
dling of the tool.
Loosen the hex socket head bolt on the handle. Move
the handle to a comfortable working position and then
tighten the bolt.
2
► 1 . Handle 2. Hex socket head bolt
11 ENGLISH
1
3
2
1