AEG RMB96716CX User Manual page 32

32 www.aeg.com
Concern
Digital temperature
displays an error.
Water/Moisture/Frost Inside Refrigerator
Moisture collects
on inside of
refrigerator walls.
Water collects
on bottom side
of drawer cover.
Water collects in
bottom of drawer.
Water/Moisture/Frost Outside Refrigerator
Moisture collects
on outside of
refrigerator or
between doors.
Food/Drinks in Fresh Food Compartment/Multi Switch drawer
Food is freezing.
Cold Drink Timer
Drinks are freezing.
Potential Cause
• Electronic control system
has detected a performance
problem.
• Weather is hot and humid.
• Flipper mullion
• Vegetables contain and give
off moisture.
• Washed vegetables and fruit
drain while in the drawer.
• Weather is humid.
• Temperature setting is too
low.
• Temperature sensor is
covered by food (right side
of fresh food area).
• Food is covering the air ports.
• Temperature setting
is too low.
• Cold drink timer is set
too long.
Common Solution
• Contact Electrolux Customer
Care for assistance.
• The rate of frost buildup and
internal sweating increases.
• Adjust flipper mullion. (See
"To adjust the flipper mullion"
in the Installation section.)
• It is not unusual to have
moisture on the bottom side
of the cover.
• Both crispers contain
an automatic humidity
control, which should adjust
automatically to the varying
levels of moisture inside
the drawer without creating
additional condensation or
drying out the air inside the
crisper drawer, works with
various types of produce.
If excess moisture is noticed,
check to verify humidity
membrane is not damaged
and replace as necessary.
• Dry items before putting
them in the drawer.
Water collecting in bottom
of drawer is normal.
• This is normal in humid
weather. When humidity is
lower, the moisture should
disappear.
• Move the setting to a higher
degree.
• Allow space for air flow
to the sensor.
• Allow space between the
air ports and the food.
• Move temperature setting
higher.
• Reduce time of cold drink
timer accordingly.