Table of Contents
Advertisement
en
Cleaning
Notes:
– To improve the amount of juice pro-
duced, preferably process ingredients
containing lots of juice at the beginning
and end of processing (e.g. oranges,
tomatoes, watermelon, etc.). Process
hard or fibrous Ingredients in-between.
– Fill the food into the feed chute one
portion at a time.
– Stuffing it in excessively does not
accelerate the processing and leads to
the drum overflowing.
Making sorbet
X Image sequence E
1. Prepare the appliance as described with
the sorbet insert piece. X "Preparing to
make sorbet" see page 13
Place a container under the aperture for
the juice. Open the sealing cap for the
juice.
2. Plug the mains plug into the mains.
Move the switch to
ance starts. The LED ring lights up
( depending on the model).
3. Add the frozen food to the feed chute.
4. Only use the pusher provided to push
the food further. The sorbet produced
will be collected in the container.
Reversing function
The reversing function is designed to
release food that has got stuck by briefly
running the worm gear in reverse.
■ Move the switch to O and wait for the
appliance to come to a stop.
■ Move the switch to { and keep it
pressed.
■ After approx. 3-5 seconds, release the
switch and wait for the appliance to
come to a stop.
■ Move the switch to
the juicing.
Note: If food that has got stuck is not
released by briefly putting the appliance into
reverse, switch the appliance off, unplug it
and clean it. X "Cleaning" see page 14
14
. The appli-
and continue with
Warning!
The reversing function must be used for
several seconds or it will no longer be pos-
sible to switch on the appliance.
After using the appliance
■ Empty both containers and then place
them under the apertures for juice and
fruit pulp again.
■ Close the sealing cap and slide the
adjusting lever for the fruit pulp all the
way to the right.
■ Pour a little water (approx. 150 ml) into
the feed chute and move the switch
to
.
■ After a short time, open the sealing cap
and slide the adjusting lever for fruit pulp
all the way to the left.
■ Let the appliance slow down and stop
completely before switching it off.
■ Move the switch to O and wait for the
appliance to come to a stop.
■ Disconnect the mains plug.
■ Clean all parts immediately after use.
Cleaning
The appliance and the individual parts used
must be thoroughly cleaned after each use.
W Risk of electric shock!
– Unplug the appliance before cleaning it.
– Never immerse the base unit in liquids
and do not clean in the dishwasher.
– Do not steam-clean the appliance.
Caution!
– Do not use any cleaning agents
containing alcohol or spirits.
– Do not use any sharp, pointed or metal
objects.
– Do not use abrasive cloths or cleaning
agents.
– Do not clean the individual parts in the
dishwasher.
Advertisement
Table of Contents
