Cleaning And Servicing; Troubleshooting - Bosch MMB64 Series Instruction Manual

en Cleaning and servicing
■ Switch on the appliance: set the rotary
switch to on.
■ Turn rotary switch to Q and hold.
or
■ Press required quick s election button
(V or Q, depending on model).
Note: The longer the appliance remains
switched on, the finer the ingredients are
cut. In the case of herbs the required cutting
result can be achieved very quickly after
switching the appliance on.
After using the appliance
■ Set the rotary switch to 0/off.
■ Remove mains plug.
■ Remove universal cutter jug by turning
it anti-clockwise.
■ Turn universal cutter jug over.
■ Remove blade holder. To do this, fold the
handle upwards and pull out the blade
holder.
■ Empty universal cutter jug.
■ Remove the rest of the chopped food
from the jug using a suitable implement
(e.g. spoon).
■ Clean all parts, see "Cleaning and
servicing".

Cleaning and servicing

The appliance requires no maintenance!
Thorough cleaning guarantees a long
service life. An overview of cleaning the indi-
vidual parts can be found in Fig. E.
W Risk of electric shock!
Never immerse the motor block in water and
never hold under running water and do not
clean in the dishwasher.
Warning!
Do not use abrasive cleaning agents.
Surfaces may be damaged.
Tips:
– Preferably clean the parts immediately
after use. This will prevent residue from
drying on and attacking the plastic
(e.g. by essential oils in herbs).
– If processing e.g. carrots and red
cabbage, the plastic parts will become
discoloured by a red film which can be
removed with a few drops of cooking oil.
18
Cleaning the motor block
■ Remove mains plug.
■ Wipe motor block with a damp cloth. If
required, use a little detergent.
■ Then wipe dry.
Cleaning blade holder
W Risk of injury from sharp blades!
Do not touch blender blades with bare
hands. Clean them with a brush.
Do not clean blade holder in the dishwasher,
but under running water using a brush. Do
not leave in water! Remove seal for cleaning.
Cleaning the blender
The blender jug, smoothie insert, lid and
measuring cup are dishwasher-safe.
Tip: Pour a little water and washing-up liquid
into the attached blender. Switch to setting
Q for several seconds. Pour out the
water and rinse the blender with clean water.
Cleaning the universal cutter
The universal cutter jug is not
dishwasher-safe.

Troubleshooting

W Risk of injury!
Before rectifying a fault, pull out the mains
plug.
Important information
The illuminated ring on the rotary switch
flashes rapidly
– if the blender jug or universal cutter jug
has not been attached properly,
– if the blender jug or universal cutter jug
becomes detached during operation,
– if the motor stops during operation due to
an overload.
Fault:
Blender does not start or appliance switches
off during operation.
Possible cause:
The appliance was overloaded (e.g. tool
jammed by food) and the electronic fuse has
tripped.