Mini Receiver Kit; Setup/Use; External Output Connections - MSA EVOLUTION Instruction Manual

SETUP/USE

The Mini Receiver Kit consists of a receiver
module packaged in a soft-sided carrying case.
The kit also contains an antenna, coaxial video
cable, and power supply cables. The following
guidelines describe its basic setup and use.
• In order to see the image seen by the remote
camera and transmitter, a display monitor
must be connected to the mini receiver. The
monitor is not supplied in this kit. Most
standard TV monitors or TV/VCR
combinations can be used.
• Connect the antenna to the connector on the
receiver unit.
• Connect the monitor to the receiver unit using
the supplied video cable.
• Connect the receiver module to power
using the 110 VAC cable or the
12 VDC car adapter.
• A red LED on the receiver module lights when
the unit is properly powered.
Prior to deploying the TIC, it is important to verify
that the transmitter and the receiver units are
synchronized to the same transmitting frequency.
Also, verify that the Evolution TIC Transmitter has
fully charged batteries. Low battery power can
result in transmission power loss, and degrade the
resulting image seen with the receiver kit.

MINI RECEIVER KIT

Figure 4.

EXTERNAL OUTPUT CONNECTIONS

The receiver unit features two video output jacks.
The jacks are BNC-style connectors that can be
used to connect the receiver output to video
monitors or VCRs. Adapter plugs are provided to
convert the BNC connection to RCA style
connections that are required for common video
equipment. The receiver simultaneously provides
output to the internal 12-inch display and the
output jacks.
Figure 5.
5