EAS Electric E150WHK User Manual page 25

Heat Pump Unit Model
Power Supply
Electric Shock Proof Grade
Water Proof Level
Heating Power Input（W）
Rated Input Power（W）
Rated Current（A）
Refrigerant/Weight
Noise（dB(A)）
Max. High Pressure（MPa）
Max. Low Pressure（MPa）
Net Weight Heat Pump Unit（kg）
Heat Pump Unit Dimension（mm）
V.2
E150WHE
200V~240V~,50Hz
Class Ⅰ
4
IPX
242
2500
11
R134a / 0.7kg
55
2.6
1.3
28.8
790*285*545
11
4. Installation Instruction
Installation place choose
4.1
Heat pump unit
The Heat pump unit can be installed firmly on the outside wall, roof, balcony or the ground.It
is not allowed to transform the internal construction of the house that could affect the
security. (It highly recommends installing the unit on the brick walls);
The distance shouldn' t allow being more than 3 meters between the heat pump unit and
the storage tank due to limited length of the connecting tube.
The installation site should be well-ventilated to ensure unimpeded of the air inlet or outlet,
as shown below:
Make sure the unit is straight enough to avoid the loud noise.
The condensate water must flow to the special container or sewer along with
the drain-pipes of the buildings.
Water tank
The tank must be floor-standing installation; the foundation of site should be solid,
firm, non-polluting, and non-corrosive.
The connector of the hot water pipe and the cold water pipe should be located nearby
water storage tank
The drain outlet should be fixed nearby the installation position for the convenient
drainage.
Water tank is required to be installed inside, outside is forbidden.
V.2
12