Intended Use; Foreseeable Misuse - Opsytec Dr. Grobel Radiometer RMD Manual

4 Identification

4.5 Intended use

The RMD determines, with the corresponding sensors, the irradiance and dose in the UV
and VIS spectral range and shows it on the integrated display. Operation is only allowed in
dry environment. If required, the sensors are available splash-proof to IP65.
When using the sensors, light, IR and UV radiation can be reflected and scattered. If
necessary, suitable protective measures must be taken to protect against radiation.
The system is intended exclusively for industrial use in ordinary locations as defined by the
National Electric Code (NEC), NFPA 70. It is prohibited to use the equipment in hazardous
areas or for general lighting.
It is prohibited to use the devices in explosive environments or for general lighting
• Installation, commissioning, operation, maintenance and service work may only be
carried out by trained and qualified personnel who comply with all safety guidelines
and standards.
• Responsibility: Damage resulting from unintentional or unauthorized interference
terminates any right to make warranty or liability claims against the manufacturer.
• Exclusion of warranty: The use of any non-original parts invalidates the warranty.
• Environmental protection: Defective parts containing environmentally harmful
substances must be disposed of accordingly.
• Only suitable for operation in closed rooms.
• Before opening, the system must be disconnected from the power supply and it
must be checked that no voltage is present.
• Wear gloves for cleaning the sensors.
• Any use other than that mentioned above will result in damage to the product. It is
also associated with hazards such as short circuits, fire and electric shock . The
entire device must not be changed and/or modified! The safety instructions must be
observed at all times.

4.6 Foreseeable misuse

The following is considered to be foreseeable misuse:
• Operation of the device without safety devices and equipment.
• Work on the device by untrained personnel.
• Non-compliance with the owner/operator's operating instructions.
• Ignoring of the operating manual.
• Processing of materials other than those specified in the technical data.
• Any other use outside the intended specified use.
7