AbleNet Quick Talker 1 Quick Start Manual

Quickstart Guide: Quick Talker ™ 1
1
Insert Battery and Turn On
1. Remove phillips screw and
battery door.
2. Insert one 9-V battery and
re-attach battery door and
phillips screw.
3. Slide power switch to on.
3
Playing A Message
1. Touch the activation area to play message.
2. Adjust volume up or down as needed.
3. You will see the visual feedback light turn on when the activation surface is touched
and message plays.
4
Erase A Message
1. To erase a message either record a new message over the existing message or hold the
record button for three seconds. You will hear an auditory beep when the message has
been erased.
Battery Door
Power ON/OFF
2
Record A Message
1. Press record button and
the visual feedback light
will turn red.
2. Touch the activation area.
When you hear the auditory beep
and the visual feedback light
starts to blink, begin recording your
message into the microphone.
3. When you are finished recording,
press the record button again.
Activation Area
Microphone
5
Low Battery Indicator Erase A Message
The following are indicators of a low battery and the battery should be replaced.
1. Immediately after a message plays, the visual feedback light blinks red three times.
2. A message begins to play, but stops before completely playing and the visual feedback
light blinks red three times after the message stops playing.
Contact & Warranty Info
Warranty/Repair/Return Information
AbleNet offers a limited two-year warranty on QuickTalker communication products. For full
warranty details, visit www.ablenetinc.com.
For more information on AbleNet products and services.
AbleNet, Inc
Minneapolis/St Paul, MN
800-322-0956 (US & Canada) / www.ablenetinc.com
© 2012 AbleNet, Inc., All Rights Reserved.
Record Button
Volume
Visual Feedback Light
PN 98000006 Rev. B (10/2012)