Parts Replaced On A Regular Basis; Before Requesting Repairs - Takara Belmont RS SWING Operating Manual

Parts Replaced on a Regular Basis

The following are parts that must be replaced on a regular basis as designated by our company:
□Drain hose: Replace every three years
・ For the drain hose, there is a possibility that water leaks will occur because cracks are caused due to
deterioration and hardening of the hose from chemical agents in the drain water.
・ Damage to the hose may result in water flooding on or beneath the floor.
□Check valve: Replace every three years
・ When the check valve is used continuously for long periods of time, there is a possibility that the parts in
the valve will deteriorate resulting in no water discharging, or sometimes, the sewage water once
discharged from the water faucet will flow back, thus causing contamination of city water or public health
problems.
□Water/hot-water supply hose: Replace every three years
・ For the water/hot-water supply hose, there is a possibility that cracks due to deterioration caused by
equipment operation or residual chlorine or copper ions in the city water will cause water leaks.
・ Damage to the hose may result in water flooding on or beneath the floor.
The above-listed parts must be replaced on a regular basis to ensure and maintain safety and performance.
Any part that is outside the designated replacement period must be replaced even if there is no problem
during use. (The parts are availabe at additlional cost.) Our company will not assume responsibility for any
harm, damage, or defects attributed to any part that was not replaced within the designated period.
For ordering replacement work, contact the Call Center.
If the following problems arise, conduct the checks outlined before requesting repairs.
S ymp to m
● Water does not come out.
● Sounds are generated when
hot water is supplied.
● The water temperature
is low.
● The water drains poorly
from the drain outlet.
● There is abnormal odor.
If the product does not operate properly after checking and repairing the above points, stop using the product immediately.

Before Requesting Repairs

Check this
Rear Cover
Are the stop valve knob or water
→
stop valves of the pipes open?
(Refer to page 20.)
Do the sounds vary when the hot water
→
amount is adjusted at the tap?
Is the temperature setup of the boiler proper?
→
Is the temperature setup of the temperature
→
control knob proper?
Is hair clogging the hair catcher?
→
Is there any contamination on the basin?
→
Stop Valve
Knob
Stop Valve
22
Sol ution
Open the stop vakve knob or
stop valves.
(Refer to page 20.)
Adjust the volume of the
water. （Refer to pages 11.)
Adjust the temperature setup of
the boiler to the proper
temperature.
Adjust the temperature setup of
the temperature control knob to
the proper temperature.
(Refer to page 15.)
Remove the hair clogging
the hair catcher.
（Refer to page 18.)
Wipe off any contamination.