Mercedes-Benz CLK-Class Owner's Manual page 373

Practical advice
Flat tyre
P 40.00-2040-31
Make sure that the base of the jack is di-
rectly below the jacking point.
Continue to turn the crank until the tyre
is raised a maximum of 3 cm from the
ground.
G
Risk of accident
Position the jack on the appropriate jacking
point only.
If you do not position the jack correctly, the
vehicle may topple off the jack.
370
P 40.10-2601-31 neu
4 Centring pin
Undo the uppermost wheel bolt com-
pletely.
In place of the wheel bolt, screw cen-
tring pin 4 from the vehicle tool kit
into the thread.
Undo the remaining wheel bolts.
!
Do not place wheel bolts in sand or on a dirty
surface. This could cause damage to the bolts
and wheel hub threads.
Remove the wheel.
Fitting a new wheel
G
Risk of accident
Only use the wheel bolts supplied.
i
Vehicles with "Minispare" emergency spare
wheel:
Only use the wheel bolts provided in the vehicle
tool kit for the "Minispare" emergency spare
wheel.
Clean the wheel and wheel hub contact
surfaces.
G
Risk of accident
Replace damaged or corroded wheel bolts.
Never oil or grease wheel bolts.