Page 1
All manuals and user guides at all-guides.com 02-20 User Guide...
Page 2
All manuals and user guides at all-guides.com...
Page 3
All manuals and user guides at all-guides.com User Guide...
Page 4
™ undertake cleaning and user maintenance. local disposal and recycling regulations for lithium-ion batteries. Do not attempt to replace the glo tobacco heater ™ cause overheating, fire, explosion and injury. T he glo heater should be charged for 2-4 hours. If ™...
Page 5
D o not drop, crush, pierce, incinerate, or immerse the ™ tobacco heater to explosive fumes or magnets. ™ D o not insert foreign objects into the glo heater. ™ O nly clean the product as advised in the User Guide, using the brush provided.
Page 6
All manuals and user guides at all-guides.com ™ gives you the instructions on The glo™ heater is only for tobacco sticks. Never use the not light a neostiks™ heatable a lighter or any other flame source.
All manuals and user guides at all-guides.com ™ tobacco heater USB cable Cleaning Brush Universal adaptor can be used. Purchase a USB cable that can support excludes neostiks ™...
Page 8
All manuals and user guides at all-guides.com 01 Heater entrance 02 Shutter 03 Control button 04 USB charger port 05 Cleaning door...
Page 9
All manuals and user guides at all-guides.com...
Page 10
Up to 25% charged Up to 50% charged Up to 75% charged Up to 99% charged Fully charged It takes 2-4 hours to fully charge provide more than 20 sessions. The glo plugged in ™ be paused until the session is complete.
Page 11
All manuals and user guides at all-guides.com Insert a neostik ™ Slide open the shutter on top of the glo tobacco ™ heater and gently insert a neostik ™ action until the coloured collar on the tipping is no longer the bottom of the glo tobacco heater.
Page 12
The glo tobacco heater ™ 3 seconds to indicate that the control button can be released. on the glo ™ illuminated and the glo tobacco heater ™ it’s ready to use. TIME UNTIL USE: 30 seconds 20 seconds 10 seconds...
Page 13
™ like a regular cigarette. Each session lasts for 3 minutes. session end to indicate the session end is approaching ™ turn off automatically. the control button for 3 seconds on the glo tobacco ™ heater. The glo ™ ™...
Page 14
™ To turn the vibrate function back on, press and hold the control button on the glo tobacco heater for 10 seconds. ™ tobacco heater ™...
Page 15
All manuals and user guides at all-guides.com Recharging To check the battery status, press and release the control button on the side of the tobacco heater. ™ The status of the battery cannot be checked during a session. See instruction 1 for further information on recharging.
Page 16
All manuals and user guides at all-guides.com Cleaning cool for a minimum of 5 minutes before cleaning. THE GLO ™...
Page 17
All manuals and user guides at all-guides.com Clean the inside of the heating chamber using the brush provided. For best results, clean from both ends as required. For best performance glo tobacco heater needs to be ™ cleaned after 20 sessions.
All manuals and user guides at all-guides.com TROUBLESHOOTING Error Mode Symptom The glo tobacco ™ heater is not charging. The glo tobacco ™ heater is not heating. The glo tobacco ™ heater is not heating.
Page 19
™ the battery’s minimum temperature. Check the battery status by pressing the button The glo tobacco on the side of the glo ™ ™ heater may have tobacco heater. Recharge ran out of battery. if necessary. Refer to the recharging instructions in the ‘Quick Start’...
Page 20
1-866-750-5893 Error #4 The temperature is too high. If you have read the troubleshooting information and tobacco ™ heater, please contact the glo customer care line ™ for additional help and advice. customer care line ™ glo.ca Toll free Phone:...
Need help?
Do you have a question about the G001 and is the answer not in the manual?
Questions and answers