Hide thumbs Also See for G001:

Advertisement

1
02-20
User Guide
EN

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the G001 and is the answer not in the manual?

Questions and answers

Summary of Contents for GLO G001

  • Page 1 02-20 User Guide...
  • Page 3 User Guide...
  • Page 4 ™ undertake cleaning and user maintenance. local disposal and recycling regulations for lithium-ion batteries. Do not attempt to replace the glo tobacco heater ™ cause overheating, fire, explosion and injury. The glo heater should be charged for 2-4 hours. If ™...
  • Page 5 Do not drop, crush, pierce, incinerate, or immerse the ™ tobacco heater to explosive fumes or magnets. ™ Do not insert foreign objects into the glo heater. ™ Only clean the product as advised in the User Guide, using the brush provided.
  • Page 6 ™ gives you the instructions on The glo™ heater is only for tobacco sticks. Never use the not light a neostiks™ heatable a lighter or any other flame source.
  • Page 7 ™ tobacco heater USB cable Cleaning Brush Universal adaptor can be used. Purchase a USB cable that can support excludes neostiks ™...
  • Page 8 01 Heater entrance 02 Shutter 03 Control button 04 USB charger port 05 Cleaning door...
  • Page 10 Up to 25% charged Up to 50% charged Up to 75% charged Up to 99% charged Fully charged It takes 2-4 hours to fully charge provide more than 20 sessions. The glo plugged in ™ be paused until the session is complete.
  • Page 11 Insert a neostik ™ Slide open the shutter on top of the glo tobacco ™ heater and gently insert a neostik ™ action until the coloured collar on the tipping is no longer the bottom of the glo tobacco heater.
  • Page 12 The glo tobacco heater ™ 3 seconds to indicate that the control button can be released. on the glo ™ illuminated and the glo tobacco heater ™ it’s ready to use. TIME UNTIL USE: 30 seconds 20 seconds 10 seconds...
  • Page 13 ™ like a regular cigarette. Each session lasts for 3 minutes. session end to indicate the session end is approaching ™ turn off automatically. the control button for 3 seconds on the glo tobacco ™ heater. The glo ™ ™...
  • Page 14 ™ To turn the vibrate function back on, press and hold the control button on the glo tobacco heater for 10 seconds. ™ tobacco heater ™...
  • Page 15 Recharging To check the battery status, press and release the control button on the side of the tobacco heater. ™ The status of the battery cannot be checked during a session. See instruction 1 for further information on recharging. 20 session available at least 5 sessions available Recharge required...
  • Page 16 Cleaning cool for a minimum of 5 minutes before cleaning. THE GLO ™...
  • Page 17 Clean the inside of the heating chamber using the brush provided. For best results, clean from both ends as required. For best performance glo tobacco heater needs to be ™ cleaned after 20 sessions. cleaning brush Please make sure that the cleaning brush is tobacco heater.
  • Page 18 TROUBLESHOOTING Error Mode Symptom The glo tobacco ™ heater is not charging. The glo tobacco ™ heater is not heating. The glo tobacco ™ heater is not heating.
  • Page 19 ™ the battery’s minimum temperature. Check the battery status by pressing the button The glo tobacco on the side of the glo ™ ™ heater may have tobacco heater. Recharge ran out of battery. if necessary. Refer to the recharging instructions in the ‘Quick Start’...
  • Page 20 1-866-750-5893 Error #4 The temperature is too high. If you have read the troubleshooting information and tobacco ™ heater, please contact the glo customer care line ™ for additional help and advice. customer care line ™ glo.ca Toll free Phone:...

This manual is also suitable for:

G002

Table of Contents