Page 1
500S Display Manual Biktrix Version Display Interface + Button Definition Normal Operation Power On/Off Press and hold the POWER button to turn on the display. With the display turned on press and hold the POWER button again to turn it off.
Headlight/Display Backlight Operation Press and hold the UP button to turn on the headlight and display backlight. To turn off the headlight when it is turned on press and hold the UP button again. *While battery voltage is low the motor may not function. However, the display and light can remain powered on for some time after this happens.
Page 3
System Display will show S7. Press the UP or DOWN button to change between Metric or imperial for speed and distance units. Press the MODE button to save changes and move to the next parameter. Brightness Display will show b1. Press the UP and DOWN buttons to change brightness of the display’s backlight.
Page 4
Wheel Display will show Hd. Press the UP and DOWN buttons to change wheel diameter setting. You do not need to change this unless you are putting different diameter wheels on your bike than it came with. Press the MODE button to save changes and move to the next parameter.
For specific definition of the error codes consult the table below. If you need assistance in resolving these errors, please contact Biktrix support. Error Code...