Advertisement
Quick Links
This wireless siren/strobe is intended for use with Honeywell Home controls that support PROSiX™ series devices.
OPEN
Gently twist the top of the Siren counterclockwise and the mounting bracket clockwise to separate them.
MOUNTING
The PROSiXSIREN can be mounted on the wall or on the ceiling.
The rear tamper breakout [A] MUST be mounted to a stud, solid wood, or with a robust wall anchor.
After enrolling, verify adequate signal strength by conducting sensor test (see controller's instructions) with the
device in its intended mounting location. Adjust the device location and orientation as necessary.
Installation and Setup Guide
PROSiXSIREN
PROSiXSIREN
Wireless Siren/Strobe
Advertisement
Related Manuals for resideo Honeywell Home PROSiXSIREN
Summary of Contents for resideo Honeywell Home PROSiXSIREN
- Page 1 PROSiXSIREN Wireless Siren/Strobe Installation and Setup Guide This wireless siren/strobe is intended for use with Honeywell Home controls that support PROSiX™ series devices. PROSiXSIREN OPEN Gently twist the top of the Siren counterclockwise and the mounting bracket clockwise to separate them. MOUNTING The PROSiXSIREN can be mounted on the wall or on the ceiling.
- Page 2 ENROLL This device can be enrolled and programmed either before or after installation. Set the control in Programming Mode and when prompted 1. Insert four 1.5V AA Lithium batteries (included) to activate the device and begin the enrollment process. 2. The Green LED flashes rapidly during enrollment (up to about 20 seconds*) *NOTE: Enrollment time varies depending on the signal strength between the device and the...
- Page 3 LEDS AND SOUNDER Refer to the table below for operation of the four bi-colored LEDs and an 85dB sounder. R / W G / W Sounder Status Green Rapid Flashes Power Up – Enrollment for about 20 seconds, once then ON for 3 seconds Green Slow Flashing Power Up –...
- Page 4 REFER TO THE INSTALLATION INSTRUCTIONS FOR THE CONTROL WITH WHICH THIS DEVICE IS USED, FOR DETAILS REGARDING LIMITATIONS OF THE ENTIRE ALARM SYSTEM. Responsible Party / Issuer of Supplier’s Declaration of Conformity: Ademco Inc., a subsidiary of Resideo Technologies, Inc., 2 Corporate Center Drive., Melville, NY 11747, Ph: 516-577-2000 The product should not be disposed of with other household waste.
Need help?
Do you have a question about the Honeywell Home PROSiXSIREN and is the answer not in the manual?
Questions and answers