Table of Contents
Advertisement
Installing the Appliance
It is a legal requirement that all gas appliances are installed by competent persons qualified in accordance with the local and Australian
regulations (Check with your individual state's regulatory body for qualified gas fitters to complete an installation of your appliance to the
appropriate regulation standard in force at the time of installation ). Failure to install the appliance correctly could invalidate any warranty
or liability claims and lead to prosecution.
The appliance shall be installed in accordance with the local and Australian standards in force at the time of installation.
Particular attention shall be given to the requirements regarding ventilation.
This appliance may not be installed in a room containing a bath or a shower.
Read these instructions before installing or using the appliance.
Ventilation
This appliance is suitable for installation into boats, recreational vehicles and caravans. The national standards regarding ventilation
must be adhered to.
The use of this cooker results in the production of heat and moisture in the area in which it is installed. Ensure that the galley is well
ventilated. Keep natural ventilation passages open or install a mechanical ventilation device.
Loose items supplied with cooker (Qty / Description)
1 x Instruction book
1 x Oven wire shelf
2 x Oven frames
1 x Grill deflector
1 x GN 1/1 pan
1 x GN 1/1 wire trivet
10 x Pan fiddle clamps (depending on model)
Positioning the Cooker
A horizontal distance of 200mm must exist between the edges of the appliance and any combustible material unless that material is protected
by a layer of non combustible material. All combustible material such as curtains and shelves must be kept well clear of the appliance. Any
fittings such as a cupboard above the cooker must have a minimum clearance of 550mm between the fitment and the top of the pan support.
Installation for Gimballing
The cooker is designed to be installed into a 'cooker box' sited between two vertical walls using the two gimbal mounting plates fitted to
appropriate wooden blocks held using M6 bolts or screws.
The cooker is set up to fit into a 660 mm gap.
To install:
1. Use the diagram below to establish the relative positions of the gimbal pivot facing bracket and gimbal lock facing bracket (on left
wall).
2. Identify a suitable position to mount the left and right hand gimbal pivot and the gimbal lock facing bracket.
3. The gimbal and gimbal lock facing brackets should be located in such a position to allow the cooker to gimbal perpendicular to the
vertical furniture walls and also to be horizontal plane.
4. Suitable mounting blocks for the gimbal pivot facing bracket and gimbal lock facing bracket in order to create a 660 mm wide gap need
to be fabricated. See pictures below.
5. Attach counterweight to base of cooker (if not already fitted) with screws provided. Lift cooker into position on the gimbal pivot facing
bracket. Attach the securing caps onto the gimbal pivot brackets using the screws provided.
6. Lift cooker into position on the gimbal pivot facing bracket. Attach the securing caps onto the gimbal pivot brackets usi n g the screws
provided.
7. Use the diagram below to establish the relative positions of the gimbal pivot facing bracket and gimbal lock facing bracket (on left wall)
4 x Sea Rails (1 front rail (low height), 3 side and back rails)
1 x 1.5V Battery size AA
2 x Gimbal pivot brackets
1 x Gimbal lock bracket
1 x Counterweight (if not supplied fitted)
12
Advertisement
Table of Contents
