Operating Instructions - SafeGuard Compass User Manual

OPERATING INSTRUCTIONS

Function
• Plug Charger into Micro USB Port:
• One RED LED indicates charging.
• One GREEN LED indicates fully charged.
Charge
• Press button during charging to display battery level. LEDs will turn
from RED to GREEN as device charges.
• Blinking RED corner LEDs indicate device should be charged ASAP.
Press Button, C
Power On
• ORANGE start-up animation.
• Center LED should blink GREEN every 5 seconds.
Press button quickly:
Mute
• GREEN LEDs = audible alerts ON
Alerts • RED LEDs = audible alerts MUTED
• Audible alerts will resume after 5min
Battery
Hold button until corner LEDs turn WHITE, then release.
Life
Hold button until corner LEDs turn BLUE then release. In this mode,
press button until your desired voltage sensitivity level is displayed in
RED (see below) then hold button down until LEDs turn GREEN to
Change
select. Repeat for current sensitivity, which will display in BLUE.
Sensitivity Voltage/Current sensitivity settings display:
1-7 LEDs, 1 is lowest sensitivity and 7 is highest.
Smart Adaptive mode: LEDs move in and out. Current detection can be
deactivated by setting sensitivity to all BLUE LEDs off.
Power
Hold button until LEDs in both corners turn ORANGE, then release.
Down
If Compass does not move for 60 seconds, the unit will go to sleep to
Sleep
conserve battery life (ORANGE corner LEDs will light up then fade,
Mode
center LED will stop blinking). When device is moved, corner lights will
turn ORANGE again and center LED blinking will resume.
Hold button down as corner LEDs cycle from WHITE to BLUE to
Reset
ORANGE. Keep holding button for several seconds after ORANGE
Device lights fade, unit reset is complete after the start-up animation has
occured.
Low
If RED corner LEDs begin blinking periodically,
Battery
charged ASAP.
sales@safeguardequipment.com
Instructions
will display:
OMPASS®
208-773-9263
C
OMPASS® should be
Display
5