Canon MP970 Service Manual page 8

the same color
installed.
Ink tank in a wrong
position.
Warning: The ink [1700, 1701]
absorber becomes
almost full.
The connected
digital camera or
digital video camera
does not support
Camera Direct
Printing.
Automatic duplex
printing cannot be
performed.
Failed in automatic
print head alignment.
The remaining ink
amount unknown.
Ink tank not
recognized.
Ink tank not [1410 to 1419] U150 The following ink tank cannot be
recognized.
No ink (no raw ink).
Non-supported hub
Unable to release
Scanner lock switch.
*1: Only for models supporting CD / DVD printing
*2: Only for models not supporting CD / DVD printing
following color is installed.
[1680] U072 Some ink tanks are not installed in
place.
--- Contact the support center or
service center for ink absorber
replacement. Press [OK] to
continue printing.
[2001] --- The device may be incompatible.
Remove the device and check the
manual supplied with the
connected device.
[1310] --- This paper is not compatible with
duplex printing. Remove the
paper and press [OK].
[2500] --- Auto head align has failed. Press
[OK] and repeat
operation. <See manual>
[1683] U130 (Applicable ink tank icon)
The remaining level of the
following ink cannot be correctly
detected. Replace the ink tank.
[1684] U140 The following ink tank cannot be
recognized.
(Applicable ink tank icon)
recognized.
(Applicable ink tank icon)
[1688] U163 The following ink has run out.
Replace the ink tank.
(Applicable ink tank icon)
[2002] --- An unsupported USB hub is
connected. Remove the hub.
[5020] --- Release the scanner lock switch
and turn the power off and back
on.
(s).
Install the ink tank(s) in the correct position.
Replace the ink absorber, and reset its counter. [See
3-3. Adjustment / Settings, (6) Service
Pressing the OK button will exit the error, and
enable printing without replacing the ink absorber.
However, when the ink absorber becomes full, no
further printing can be performed unless the
applicable ink absorber is replaced.
Remove the cable between the camera and the
machine.
The paper length is not supported for duplex
printing.
Press the OK button to eject the paper being used at
error occurrence.
Data which was to be printed on the back side of
paper at error occurrence is skipped (not printed).
Press the OK button to clear the error, then perform
the automatic print head again.
(In the MP610, use Matte Photo Paper MP-101.)
An ink tank which has once been empty is installed.
Replace the applicable ink tank with a new one.
Printing with a once-empty ink tank can damage the
machine.
To continue printing without replacing the ink tank
(s), press the Stop/Reset button for 5 sec. or longer
to disable the function to detect the remaining ink
amount. After the operation, it is recorded in the
machine EEPROM that the function to detect the
remaining ink amount was disabled.
A non-supported ink tank is installed (the ink tank
LED is turned off). Install the supported ink tanks.
A hardware error occurred in an ink tank (the ink
tank LED is turned off). Replace the ink tank(s).
Replace the empty ink tank(s), and close the
scanning unit (printer cover).
Printing with an empty ink tank can damage the
machine.
To continue printing without replacing the ink tank
(s), press the Stop/Reset button for 5 sec. or longer
to disable the function to detect the remaining ink
amount. After the operation, it is recorded in the
machine that the function to detect the remaining
ink amount was disabled.
Remove the applicable USB hub from the
PictBridge (USB) connector.
Unlock the scanner lock switch, turn the machine
off, then turn the machine on again.
6 / 45
mode.]