Function Settings By Using Remote Controller - Fujitsu ACUH09LUAS1 Design & Technical Manual

9-2. Function settings by using remote controller

Some function settings can be changed on the remote controller. After confirming the setting proce-
dure and the content of each function setting, select appropriate functions for your installation envi-
ronment.
¢ Setting procedure by using remote controller
Remote controller is not attached for this product. For details of the installing remote controller, refer
to following information.
• Overview information: Operating manual of the remote controller
• Setting procedure: Installation manual of the remote controller
¢ Contents of function setting
Each function setting listed in this section is adjustable in accordance with the installation environ-
ment.
NOTE: Setting will not be changed if invalid numbers or setting values are selected.
 Function setting list
Function no.
1) 11
2) 20
3) 22
4) 30/31
5) 35/36
6) 40
7) 42
8) 44
9) 46
10) 48
11) 49
12) 60
13) 61
14) 62
15) 66
16) 67
17) 71
18) 72
19) 73
20) 75
1) Filter sign
Select appropriate intervals for displaying the filter sign on the indoor unit according to the estimated
amount of dust in the air of the room.
If the indication is not required, select "No indication" (03).
Function number
11
9-2. Function settings by using remote controller
Filter sign
Ceiling height
Outlet directions
Room temperature control for indoor unit sensor
Room temperature control for wired remote controller sensor
Auto restart
Room temperature sensor switching
Remote controller custom code
External input control
Room temperature sensor switching (Aux.)
Indoor unit fan control for energy saving for cooling
Switching functions for external output terminal
Control switching of external heaters
Operating temperature switching of external heaters
Outdoor temperature zone boundary temperature A
Outdoor temperature zone boundary temperature B
Standby time for auxiliary equipment operation
Heat pump backup setting
Emergency heat for external output terminal
External heater use in defrosting
Setting value
00
01
02
03
Functions
Setting description
Standard (2,500 hours)
Long interval (4,400 hours)
Short interval (1,250 hours)
No indication
- 57 -
Factory setting
♦
9. Function settings