Advertisement
16
www.raider.bg
dust, use a specialized vacuum cleaner.
11. Operating the power tool.
11.1. Adjusting the cutting angle.
For sloping cuts, the base plate can be tilted to the right or left to 45 °. Unscrew the screws and move the base plate slightly. To fix
accurate slopes, the base plate is fixed at 0 °, 22.5 °, and 45 ° to the left and right. Tilt the base plate to the desired angle. Random
slopes can be set using a carrier. Then tighten the screws again
12 Operating instructions.
Cooling-lubricating fluid. To prevent overheating when cutting metals, you must apply a coolant-lubricating fluid along the cutting line.
The speed of rotation of the saw engine is adjusted by turning and adjusting the speed governor to the desired position. This allows
you to choose the most suitable work rate depending on the properties of the material to be treated. The higher the value indicated
on the regulator, the higher the engine speed of the saw. For faster operation, the jig saw is equipped with a pendulous movement
of the knife.
13. Maintenance and service.
13.1. Maintenance and cleaning.
To work well and safely, keep the power tool and ventilation holes clean. Regularly clean the blade attachment blade. To do this,
remove the cutting sheet and shake the adhering chips by gently tapping on a stable base. Strong contamination of the chain saw
may cause malfunctions. Therefore, do not cut materials that release a large amount of chips and dust from the bottom or ceiling.
13.2. In extremely heavy working conditions when cutting metals on the inside surfaces of the casing, a current-carrying powder can
be deposited. This may interfere with the protective insulation of the jig saw. In such cases it is recommended to use a stationary
aspiration system, frequent blowing of the ventilation openings. Periodically lubricate the guide roller with one drop of machine oil.
Regularly check the guide roller. If it is worn, it must be replaced by an authorized RAIDER service center.
14. Environmental protection.
In order to protect the environment, the power tool, accessories and packaging must be suitably processed for the reuse of the
raw materials contained therein. Do not dispose of power tools in household waste! According to the EU Directive 2012/19 / EC
on end-of-life electrical and electronic devices and its validation as a national law, power tools that can no longer be used must be
separately collected and subjected to appropriate processing to recover the contents in them valuable secondary raw materials.
Advertisement
