Operation - Laserworld Ecoline Series Manual

Manual: Ecoline Series EL-D100G

8. Operation

1. Connect the power cable to the device and then to the mains
2. Insert key and turn it ‚ON' and turn the switch ‚ON'
3. Your device runs in auto mode:
Your device runs in music mode:
4.
Control the music-sensitivity by the trim pot at the front side of the device. The LED is
flashing when the device is triggered.
5. Your device runs in DMX mode if '10' is switched off:
Connect a DMX controller to operate the laser.
Use the switches 1 - 9 to set the DMX address of the laser. Each switch represents a num-
ber. To define a number use the preceding number and multiply it by 2:
1
Switch
Number 1
The laser uses 7 DMX channels, so make sure that the next device uses an address that
doesn't overlap with this range.
page 7 / 24
2 3 4
2 4 8
5 6 7
16 32 64
8 9 10
128 256 Mode Switch