Advertisement
OWNER'S MANUAL
PRO-Source
Plus
®
Steel Pressure Tanks
6709 1112
Installation/Operation/Parts
For further operating, installation,
or maintenance assistance:
Call 1-262-728-5551
293 WRIGHT STREET, DELAVAN, WI 53115 WWW.STA-RITE.COM
PH: 262-782-5551
PSP973 (03/27/13)
© 2013 Pentair, Ltd. All Rights Reserved.
Advertisement
Table of Contents
Related Manuals for Pentair STA-RITE PRO-Source Plus
Summary of Contents for Pentair STA-RITE PRO-Source Plus
- Page 1 OWNER’S MANUAL PRO-Source Plus ® Steel Pressure Tanks 6709 1112 Installation/Operation/Parts For further operating, installation, or maintenance assistance: Call 1-262-728-5551 293 WRIGHT STREET, DELAVAN, WI 53115 WWW.STA-RITE.COM PH: 262-782-5551 PSP973 (03/27/13) © 2013 Pentair, Ltd. All Rights Reserved.
- Page 2 Safety READ AND FOLLOW RULES FOR SAFE SAFETY INSTRUCTIONS! INSTALLATION AND OPERATION This is the safety alert symbol. When you see this symbol on your pump or in this Read the Owner’s Manual and Rules for Safe manual, look for one of the following signal words Operation and Installation Instructions carefully.
-
Page 3: General Information
General Information GENERAL INFORMATION NOTICE: Replace and tighten air valve cap if it is re moved for any reason. Failure to replace air cap All tanks are factory pre-charged with air. When may allow loss of air pressure and eventually lead installing tank, adjust pre-charge to 2 PSI below to tank waterlogging and water cell failure. -
Page 4: Installation
Installation TO CHECK TANK AIR CHARGE Connect system pipe to tank flange. Use plastic or steel pipe as required. To prevent leaks, use PTFE If drawdown (amount of water available per cycle) pipe thread sealant tape on male threads of all decreases significantly, check as follows: threaded connections to tank. - Page 5 Installation B. Reconnect power supply to pump and adjust 6. Before new water cell can be inserted into tank, pressure in system. it must be tightly rolled up as follows: C. Disconnect power supply to pump again and A. Place water cell on clean surface with open- re-check switch setting.
-
Page 6: Air Valve Replacement
Installation 11. Clean sealing surface and groove of cover E. Recheck all nuts, using same pattern. Be sure all flange; place on tank (see Figure 5). Be sure to nuts are tight and that you have a good seal. capture the base with the flange (the tabs on the NOTICE: Do not overtighten;... -
Page 7: Repair Parts
Repair Parts Models PSP19S-T02SA-25PSI PSP19T-T02SA-25PSI PSP35-T05SA-25PSI PSP50-T50SA-25PSI PSP85-T52SA-25PSI PSP119-T50SA-25PSI 3946 0401 REPAIR PARTS LIST – Pro-Source Plus Tanks PSP19S-T02 PSP19T-T02 PSP35-T05 Part Description SA-25PSI SA-25PSI SA-25PSI Used 19 Gal. 19 Gal. 35 Gal. Air Valve with Cap U212-266 U212-266 U212-266 Water cell - Vinyl U20-8 U20-15S...
Need help?
Do you have a question about the STA-RITE PRO-Source Plus and is the answer not in the manual?
Questions and answers