Infinite Restarts - Phase Technology Phase Perfect PT007 Operation & Installation Manual

Infinite Restarts

WARNING! Risk of electric shock. De-energize the unit by disconnecting all incoming
sources of power, then wait 30 minutes for internal charges to dissipate before servicing
the equipment.
Infinite Restarts will allow the converter to restart an unlimited number of times after fault
conditions. This procedure will require wiring two ON/OFF switches to the converter.
Standard light switches will work. See Figure 25 for wiring diagram. To add a startup delay,
follow the steps below:
Wait several seconds until "Programmed Successfully" is shown on the display, and then
return switches to the OFF position. Turn power to converter OFF, re-install jumper wire
between AUX1 and COM, then reapply power to converter.
Step
1 Turn power to PT OFF
Remove jumper wire between AUX1
2
Wire dry contact switch between AUX3
3
and COM (now called SW3)
Wire dry contact switch between AUX4
4
and COM (now called SW4)
5 Turn power to the PT ON
Toggle SW4 until you see INFINITE
6
RESTARTS on screen
Toggle SW3 to select between YES or
7
Action
and COM
NO
V2.1
28 | Page