Operation; Lcd Status Screen; Dip Switch Settings - Phase Technology Phase Perfect PT007 Operation & Installation Manual

OPERATION

LCD Status Screen

When the unit is powered up, the screen will scroll through the operating parameters.
Figure 22 – Status Screen

DIP Switch Settings

WARNING! Make sure the input power disconnect switch is in the OFF position
before opening the front cover to the unit. Opening the front cover with the switch in the ON
position exposes the user to the risk of electric shock.
WARNING: Risk of electric shock. Disconnect all incoming sources of power and wait
30 minutes before opening the front cover to change the DIP switch.
Figure 24 – Location of DIP Switches and Slide Switches
DIP Switch
2
9 & 10
10
Table 22 – DIP Switch Settings
Function
Disable Auto Restarts
Bypass AUX1 & AUX2 both ON
Enable VFD Mode note: SW9 must be OFF
Figure 23 – "System Off" Status Screen
Main DIP
Switch Array
V2.1
Factory-Installed
Jumper Wire
Default
OFF
OFF/OFF
OFF
23 | Page