Peco Estate Series Operator's Manual page 27

Wiring Harness Installation (Cont.)
Pasture Vac Instructions
To connect the Wiring Harness, connect the 10 gage Red Wire P#(P0278) from the positive (+) terminal of the starter
solenoid located on the front end of the engine to the positive (+) terminal of the battery. Refer to the Figure below.
Then, connect the 10 gage Black Wire P#(P0279) from one of the mounting bolt holes located on the bottom of the
engine or one of the bolt holes located on the Engine Mount Arm to the negative (-) terminal of the battery. Refer to
the Figure below.
Universal Battery Kit P#(A2326)
Negative (-) Terminal
Connection
(Engine Mount Arm)
Positive (+) Terminal
Connection (Solenoid)
27