Siemens SIMATIC NET Installation Manual page 29

Device Management
3.1 Connecting to the Device
Serial Console and Management Ports
Connect a workstation directly to the serial console or management ports to access
the boot-time control and RUGGEDCOM RX1511 interfaces. The serial console port
provides access to RUGGEDCOM RX1511 's console interface, while the management
port provides access to RUGGEDCOM RX1511's console and Web interfaces.
Connection to the console port is made using an RJ-45-to-DB9 console cable. The
following is the pin-out for the console port:
8
Figure 3.1
a
The DSR, DCD and DTR pins are connected together internally.
b
The CTS and RTS pins are connected together internally.
c
RI is not connected.
For information about how to connect to the device via the serial console port, refer
to the RUGGEDCOM ROX CLI Configuration Manual for the RUGGEDCOM RX1511.
For information about how to connect to the device via the management port,
refer to either the RUGGEDCOM ROX Web Interface Configuration Manual or the
RUGGEDCOM ROX CLI Configuration Manual for the RUGGEDCOM RX1511.
The management port is a 10/100Base-TX copper Ethernet port with an RJ-45
connector. The following is the pin-out for the management port:
8
Figure 3.2
20
1
RJ-45 Console Port Pin
Configuration
1
RJ-45 Management Port
Pin Name
RJ-45 DB9
Male Female
1 6 DSR
2 1 Reserved (Do Not Connect)
3 4 DTR
4 5 GND
5 2 RxD
6 3 TxD
7 8 CTS
8 7 RTS
9 RI
Pin Name
1 RX+
2 RX-
3 TX+
4 Reserved (Do Not Connect)
5 Reserved (Do Not Connect)
6 TX-
7 Reserved (Do Not Connect)
8 Reserved (Do Not Connect)
Installation Manual, 04/2021, C79000-G8976-1056-20
Description
a
Data Set Ready
a
>Data Terminal
Ready
Signal Ground
Receive Data
(to DTE)
Transmit Data
(from DTE)
b
Clear to Send
b
>Read to Send
c
Ring Indicator
Description
Receive Data+
Receive Data-
Transmit Data+
Transmit Data-
RUGGEDCOM RX1511