Tire Maintenance - Landoll 345B Operator's Manual

4-11 TIRE MAINTENANCE

4-11.1 Tire Inflation. Tire inflation will cause
tire to ground contact characteristics as
shown in Figure 4-15. Tire inflation should
be checked daily while the tire is cold, and
during road stops. Checking the tire pres-
sures while tires are hot will give a faulty in-
creased pressure reading. Adjusting tire air
pressure to the specified amount while tires
are hot will produce improper tire to road
contact and thus abnormal wear. Do not ex-
ceed cold inflation pressure listed on the
trailer VIN plate located on the front of the
trailer. Exceeding cold inflation pressure will
result in damaged tire bodies, rims, and
wheels. Replace all valve stem caps when
pressure checking/adjusting has been com-
pleted. Remove any foreign objects from be-
tween duals.
Figure 4-16 Measuring Tape Method
Figure 4-15 Tire Inflation Examples
4-11.2 Tire Matching. Both tires on the same
spindle must be the same size in order to
properly distribute the load and braking forces
between them. The tire must be mounted on a
rim and properly inflated before measuring. If
there is an allowable difference in size the
smaller tire should be mounted to the inside
position of the duals.
a. Tape Measuring Method: Measure around
each tire on the tread surface. A maximum
difference of 3/4" is allowed between the two
mating tires of a dual (See Figure 4-16).
Figure 4-17 Straight Edge Method
4-23