Dock Leveler Control - Landoll 345B Operator's Manual

3-15 DOCK LEVELER CONTROL

3-15.1 To activate the dock level hydraulic cir-
cuit, pull out on the push-pull selector valve
located on the left driver's side of trailer bed
near the front.
3-15.2 The DOCK LEVELER CONTROLS are
located under the deck, on the driver's side,
between the axles (See Figure 3-6). The
front-most control adjusts the cylinder on the
driver's or street side of the trailer. The rear-
most control adjusts the cylinder on the
curb-side of the trailer. Both controls have
three position.
Figure 3-6 Dock Leveler Controls
IN
CENTER
OUT
3-15.3
When the control for either cylinder
is pushed in, toward the center of the
trailer, the corresponding side of
trailer is lowered.
This position is neutral for either con-
trol. When either control is in this po-
sition, there is no effect on either cyl-
inder.
When the control for either cylinder
is pulled out, away from the center of
the trailer, the corresponding side of
trailer is raised.
After completion of dock level use re-
turn the push-pull selector valve to full in po-
sition.
3-13