Microlife BP3GX1-5A Instruction Manual page 20

5.5. Memory: Reviewing readings
At the end of a measurement, this monitor automatically
stores each result with date and time. This unit stores 99
memories for each of 2 users.
Viewing the stored values
With the unit off (or with only the time and user icons
showing), press the "M" button. The display first shows
"A," then shows an average of all measurements stored
in the unit. Please note: Measurements for each user are
averaged and stored separately. Be certain that you are
viewing the measurements for the correct user.
Pressing the "M" button again displays the previous
value. To view a particular stored memory, press and hold
the "M" button to scroll to that stored reading.
Memory full
When the memory has stored 99 results, a new,
measured value is stored by overwriting the oldest value.
Clear all values
If you are sure that you want to permanently remove all
stored values, hold down the "M" button (the instrument
must have been switched off beforehand) until "CL"
appears and then release the button. If you do not want
to clear the values, press the POWER button. To
permanently clear the memory, press the "M" button
1
while "CL" is flashing.
Individual values cannot be cleared.
5.6. Stopping a measurement
If it is necessary to interrupt a blood pressure measure-
ment for any reason (e.g., the patient feels unwell), the
POWER button can be pressed at any time. The device
then immediately lowers the cuff pressure automatically
and enters sleep mode.
19