Microlife BP3GX1-5A Instruction Manual page 13

4.2. Setting the date and time
1. After the new batteries are activated, the
year number flashes in the display. You
can advance the year by pressing the "M"
button. To confirm and then set the
month, press the TIME button.
2. You can now set the month using the "M"
button. To confirm and then set the day,
press the TIME button.
3. Please follow the instructions above to
set the day, hour and minutes.
4. Once you have set the last minute and
pressed the TIME button, the date and
time are set and the time is displayed.
5. If you want to change the date and time,
press and hold the TIME button down for
approximately 3 seconds until the year
number starts to flash. Now you can enter
the new values as described above.
4.3. Using the AC power adapter
You may also operate this monitor using the
included AC adapter. Use only the included
AC adapter to avoid damaging the unit.
a) Ensure that the AC adapter and cable are
not damaged.
b) Plug the adapter cable into the AC
adapter port on the right side of monitor.
c) Plug the AC adapter into a 110 V power
socket (U.S. or Canada).
d) Test that power is available by pressing
the POWER button.
Note:
• No power is taken from the batteries
while the AC adapter is connected to the
instrument.
12