Connecting The Optical Fibres; Check Module Leds - technetix AIMA3000.FT5X Product User Manual

AIMA3000.FT5X Product User Manual

5.4.4 Connecting the Optical Fibres

Carefully lift up the hinged cover of the optical input port, align the raised tab on the connector with the slot in the port.
Insert the connector until the connector is securely held in place indicated by a clicking sound.
Figure 5-5

5.5 Check Module LEDs

When the module has been installed, if the chassis is powered, all LED indicators on the front panel will show a blinking
green light, indicating the module is initiating.
If the input signal and output signal are normal, the "STAT" LED indicator will cease to blink in about 5 seconds and remain
constant green afterwards. At the same time, the "LSR" LED indicators will also remain constant green when the signals
are normal.
If the RF input signal or the optical output signal is out of the expected range, the "STAT" and "LSR" LED indicator will show
constant orange or red.
Technetix Group Limited
May/2016 - Version 1.0 sales@technetix.com • technetix.com 26