Emptying The Dust Cup; Cleaning The Filters - Shark Rotator Lift-Away ADV LA500 Series Owner's Manual

EMPTYING THE DUST CUP

IMPORTANT: Unplug the power cord before performing any maintenance.
To remove the Dust Cup, slide up on the release
button located on the side of dust cup handle.
Tilt dust cup forward, then lift to remove.
Clear debris from the Lint Screen in the dust
cup. Lift the upper release tab at the top of
the dust cup and open the lid. Gently brush
the lint screen to remove debris.
s h a r kc l e a n . c o m
To empty debris into the trash, press the lower
release button and the bottom of the dust cup
will drop open.
To reinstall, place the bottom of the dust cup
onto the pod and then tilt until it clicks into
place.

CLEANING THE FILTERS

Regularly rinse the filters to maintain your vacuum's suction power.
Rinse filters with cold water only. Allow all filters to air-dry for at least 24 hours before
reinstalling them to prevent liquid from being drawn into electronic parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
Foam
Felt
RINSE PRE-MOTOR FILTERS
EVERY MONTH
Remove the Dust Cup, then lift out Filters.
Post-Motor
Filter
HEPA Filter
Door
RINSE HEPA FILTER
EVERY YEAR
To remove the HEPA Filter, first pull the tab
on the bottom of the filter door, then lift off
the door. Press the tab on the side of the
HEPA filter and pull out the filter.
To reinstall the door, align the top first, then
press in the bottom until it clicks into place.
s h a r kc l e a n . c o m