Table of Contents
Advertisement
NOTE: Do not fill with ingredients/liquid past the max fill line.
NOTE: Maximum runtime of a single blending cycle is one minute.
OPERATING AND SAFETY TIPS
• Always use the blender on a clean, sturdy and dry surface.
• Always operate the blending cup with blade assembly attached.
Place cover on firmly.
• Don't remove blending cup while unit is running.
• Don't place blade onto blender base without the blending cup
attached.
• Make sure blade assembly is tightly attached to blending cup.
• Always remove blade assembly before cleaning.
• Don't store food or liquids in your blending cup.
• Don't overload blending cup.
• CAUTION: NEVER use carbonated beverages in the blending cup.
• Don't blend hot liquids in blending cup.
• Don't use any container or accessories not recommended
by Cuisinart
®
. Doing so may result in injury.
• The blending cup is not recommended for microwave use.
CLEANING AND MAINTENANCE
The base and parts are made of corrosion-resistant materials that are
easy to clean. Before first use and after every use, clean each part
thoroughly. Periodically check all parts before reassembly.
DO NOT USE if any part is damaged, or the cup is chipped or cracked.
To remove blade assembly, twist off by turning counterclockwise.
NEVER TOUCH THE BLADE ITSELF.
CAUTION: Handle the blade assembly carefully. The blades are
SHARP and may cause injury. DO NOT attempt to remove blades
from cutting assembly.
Wash all parts in warm, soapy water; rinse and dry thoroughly.
All parts are top rack dishwasher safe.
Tip: You may wish to clean your blade assembly as follows: Squirt
a small amount of dishwashing liquid into travel cup and fill halfway
with warm water. Attach blending blade assembly. Run for 15 seconds.
Repeat, using clean tap water. Carefully disassemble parts and empty
cup. Rinse and dry all parts thoroughly. Finally, wipe the motor base
clean with a damp cloth to remove any residue, and dry thoroughly.
Never submerge the motor base in water or other liquids, or place
in a dishwasher.
Any other servicing should be performed by an authorized service
representative.
TIPS AND HINTS
• When using your blending cup, ingredients are put in the following order:
Always put the hardest ingredients into the travel cup first (ice cubes,
frozen fruit), and finish with the softer ingredients and liquids.
• It is recommended that most foods be cut into ½-inch to 1-inch
(1.25 cm to 2.5 cm) pieces to achieve the most uniform result.
• If food sticks to the sides of the cup when blending, stop the blender,
carefully scrape down the food, replace blade assembly and blend
again to combine.
• When blending thicker mixtures, lightly hold down the top of travel cup
to prevent jumping.
• After blending, flip the travel cup over so that the blade assembly is on
the top. Gently tap the travel cup a few times to prevent any spillage.
Remove the blade assembly and replace with lid.
• Some recipes may require more than a minute of blending. Simply
start blender again, once the minute of continuous blending has elapsed.
7
Advertisement
Table of Contents
