Advertisement

Yalp Memo
YA 3900
Installation instructions
EN
Installatievoorschrift
NL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Yalp Memo YA 3900 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for LAPPSET Yalp Memo YA 3900

  • Page 1 Yalp Memo YA 3900 Installation instructions Installatievoorschrift...
  • Page 2 WARNING WAARSCHUWING Read these installation instructions before you Lees deze installatieinstructies voordat u dit start the installation. Retain this manual for toestel installeert. Bewaar deze handleiding future reference. voor toekomstig gebruik. YA3900-201006...
  • Page 3 Yalp Memo YA 3900 YA3900-201006...
  • Page 4 A . 1 1200 mm 1240 mm [47.2”] [26.2 ft] 240 kg 290 kg 530 lbs 640 lbs YA3900-201006...
  • Page 5 A . 2 [26.2 ft] 311 mm [13.0”] YA3900-201006...
  • Page 6 A . 3 Glue mixer M10x30 Glue 100-282 Seam Tape 40 m Pin Torx T45 100-274 160-200 160-010 Floor PVC 2,90m [114,2"] / Ø32mm [1,3"] PVC Glue 160-710 160-720 160-620 160-614 160-605 160-608 180x 100-243 M8x80 100-281 100-271 YA3900-201006...
  • Page 7 24 mm Cordless drill Flat (insulated) Stanley knife Measuring tape M8 Tap bit Sharp Round 0.06-2mm 0.2-1mm Shovel Wire stripper 50-100 L 3500kg 1250 kg (Rotary) broom Leveller Phillips PH2 900 kg C20/25 13 mm Concrete cutter 20 m / Ø32 mm Drill + bit 8.8 anchor M20 350-450kg C20/25...
  • Page 8 A . 4 >1,5 m >[4.9 ft] A . 5 18mm, <2,5mm YA3900-201006...
  • Page 9 A . 6 A . 7 YA3900-201006...
  • Page 10 A . 8 >100 mm [>3.9”] YA3900-201006...
  • Page 11 B . 1 [9.8 ft] [13.1 ft] YA3900-201006...
  • Page 12 B . 2 YA3900-201006...
  • Page 13 B . 3 600 mm [23.6"] 100 mm [3.9"] 200 mm 750 mm [7.9”] [29.5”] Shovel YA3900-201006...
  • Page 14 B . 4 WARNING 50 mm [2”] B . 5 300 mm [11.8”] C20/25 YA3900-201006...
  • Page 15 B . 6 [9.84 ft] 50 mm [2”] PVC Glue YA3900-201006...
  • Page 16 B . 7 300 mm [11.8”] C20/25 B . 8 B . 9 YA3900-201006...
  • Page 17 C . 1 3,2 m [9.8 ft] [13.1 ft] YA3900-201006...
  • Page 18 C . 2 183 mm [7.2”] Shovel YA3900-201006...
  • Page 19 C . 3 WARNING 120x 100-243 100-281 100-271 YA3900-201006...
  • Page 20 C . 4 100-243 M8x80 100-281 100-271 YA3900-201006...
  • Page 21 C . 5 50 mm 50 mm [2”] [2”] C . 6 YA3900-201006...
  • Page 22 D . 1 [9.8 ft] [13.1 ft] YA3900-201006...
  • Page 23 D . 2 58 mm [2.3”] YA3900-201006...
  • Page 24 D . 3 YA3900-201006...
  • Page 25 D . 4 60 mm [2.4"] 60 mm [2.4”] Concrete cutter YA3900-201006...
  • Page 26 D . 5 YA3900-201006...
  • Page 27 D . 6 20 m / Ø32 mm [9.84 ft] YA3900-201006...
  • Page 28 D . 7 NOTICE WARNING Drill + bit D . 8 8.8 anchor M20 YA3900-201006...
  • Page 29 D . 9 NOTICE Drill + bit D . 10 8.8 anchor M20 D . 11 D.10 YA3900-201006...
  • Page 30 D . 12 350-450kg C20/25 YA3900-201006...
  • Page 31 E . 1 YA3900-201006...
  • Page 32 E . 2 E . 3 M10x30 100-282 100-274 YA3900-201006...
  • Page 33 E . 4 E . 5 Pin Torx T45 E . 6 YA3900-201006...
  • Page 34 E . 7 M10x30 100-282 100-274 E . 8 WARNING Wire stripper Flat (insulated) YA3900-201006...
  • Page 35 E . 9 CLICK! E . 10 Pin Torx T45 100-210 YA3900-201006...
  • Page 36 E . 11 NOTICE my.yalp.com 40-120 s YA3900-201006...
  • Page 37 E . 12 20 mm [0.75”] Sharp 0.06-2mm 3500kg 20 mm [0.75”] Sharp 0.06-2mm 3500kg YA3900-201006...
  • Page 38 E . 13 50-100 L YA3900-201006...
  • Page 39 E . 14 YA3900-201006...
  • Page 40 E . 15 YA3900-201006...
  • Page 41 E . 16 [26.2 ft] YA3900-201006...
  • Page 42 E . 17 NOTICE YA3900-201006...
  • Page 43 E . 18 YA3900-201006...
  • Page 44 E . 19 Round 0.2-1mm 500kg E . 20 YA3900-201006...
  • Page 45 E . 21 YA3900-201006...
  • Page 46 F . 1 F . 2 YA3900-201006...
  • Page 47 F . 3 F . 4 YA3900-201006...
  • Page 48 F . 5 F . 6 YA3900-201006...
  • Page 49 F . 7 F . 8 YA3900-201006...
  • Page 50 F . 9 F . 10 YA3900-201006...
  • Page 51 F . 11 YA3900-201006...
  • Page 52 F . 12 F . 13 YA3900-201006...
  • Page 53 F . 14 F . 15 YA3900-201006...
  • Page 54 F . 16 F . 17 YA3900-201006...
  • Page 55: Product Specifications

    Lappset Yalp B.V. (hereina er referred to as Yalp) has made every eff ort to ensure that these installa on in- struc ons are accurate.
  • Page 56 Installed Sona (L x W x H) 4.965x3.800x3.782 m 195.5x149.6x148.9” Sona Turf Floor (uncut) Ø3900mm Ø153.5” Recess radius Ø3800mm Ø149.6” Recess depth 20 mm 0.8” Weight Netto weight Sona 590 kg 1300 lbs Power Power input 100-240 V ~. 50/ 60 Hz. 150W max Power output 12 V DC Energy usage...
  • Page 57: Regulatory Information Usa

    REGULATORY INFORMATION USA Changes or modifi ca ons not expressly approved by the party responsible for compliance could void the us- er’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Opera on is subject to the following two condi ons: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired opera on.
  • Page 58: Rf Exposure Safety

    We, Lappset Yalp B.V., hereby declare that the equipment bearing the model name specifi ed below was tested conforming to the applicable FCC Rules under the most accurate measurement standards possible, and that all the necessary steps have been taken and are in force to assure that produc on units of the same equip- ment will con nue to comply with the Commissions requirements.
  • Page 59 100-235 Anchor FE360 Galvanized 100-507 Transparent sealant 3200-910 Mould Pinewood 100-213 Button head screw SS304 Lubocoat M10x30 BIT TX45 Torx bit FE360 Galvanized HAND TX45 Torx hand key FE360 Galvanized 100-240 Hex bolt M8x20 FE360 Galvanized 100-243 Hex bolt M8x40 FE360 Galvanized 100-245...
  • Page 60 Surface mount Drill + bit Advised for anchors Chemical anchor (4000N) e.g. Hilti HIT 170 with 8.8 anchor M20 (in combination with C20/ C25 concrete) A. PREPARATION A.1 TRANSPORTATION ADVICE WARNING Not taking the right precautions • While unpacking the product check the product could result in accidents and/or damage.
  • Page 61: Surface Mount

    A.10 Choose the installation type suitable for the DEEP mount (in existing ground): continue with surface on which the Sona will be installed. part B WARNING A surface mount can only be done SURFACE mount (on top of existing surface): when the existing surface is made of at least 15 continue with part C cm (5.9”) solid concrete.
  • Page 62: Power Cycle

    WARNING Electric malfunction risk! Connecting D.16 Switch on the main power. the cables without switching of the main power, For settings, service and statistics, visit NOTICE could cause a damage to the product and electric the My Yalp section in the Yalp Store. shock risks.
  • Page 63 Make sure the product can perform a daily restart every day for op mal performance MAINTENANCE FLOORING Brush the grass regularly with a s ff broom or rake Keep the grass free of debris and leaves Remove leaves using a leaf blower or rake Remove any weeds immediately to prevent seed dispersal Use clean water to rinse off...
  • Page 64 Deze installa ehandleiding voorziet niet in informa e omtrent alle mogelijke productvaria es of eventuele toevalligheden die jdens de installa e, het gebruik of het onderhoud van het product kunnen voorvallen. Lappset Yalp B.V. (hierna “Yalp” genoemd) hee er alles aan gedaan om ervoor te zorgen dat deze installa e- handleiding correct is.
  • Page 65 Gewicht Ne o gewicht Sona 590 kg 1300 lbs Energiegebruik Aansluiting 100-240 V ~. 50/ 60 Hz. Max. 150W Uitgang 12V DC Energiegebruik 3,4W Vermogen in gebruik (gemiddeld) Vermogen in gebruik met lichtset (gem.) Vermogen in idle (standby) 3,2W Vermogen in slaap 3,2W Aansluiting Internet connectie...
  • Page 66 199-017 Zijpaneel met knop SS304 Poedercoat 199-024 Zijpaneel SS304 Poedercoat 199-101 Boog frame FE360 Poedercoat 199-111 Polyester kappen Polyester 199-221 L klem SS304 Thermisch verzinkt + poedercoat 199-231 Stelplaatje FE360 Thermisch verzinkt 199-320 UFO camera schijf Electronics 199-501 Kunstgras vloer Turf 100-235 Anker...
  • Page 67 Stanley mes Bezem Evenaar Kruis schroevendraaier Vulzand #30 Silica rond 0.2-1mm #30 Silica rond 0.008-0.04” Grondmontage Sneldrogend beton (C20/C25 NEN 800 kg 1764 lbs -EN206-1/-8005) Opbouw montage Klopboor Betonfrees Chemisch anker (4000N) bijv. Hil HIT 170 met 8.8 anker M20 (in combina e met >...
  • Page 68 WARNING De stroomkabel naar het toestel dient te • Zorg voor voldoende drainage. worden gezekerd op een aparte groep in de meterkast met A.10 Kies het installa etype dat geschikt is voor het een 30mA RCD, voorzien van een 10A of 16A zekering. oppervlak waarop de Solarpaal geïnstalleerd zal worden.
  • Page 69 D.9 Draai alle bout/moer verbindingen vast in de top en aan NOTICE Zorg ervoor dat de plus- en minpolen op de de basis van het boogframe. juiste manier aangesloten worden. D.10 Verbindt de polyester kappen ook bovenin aan het D.14 Monteer de zijkappen. frame.
  • Page 70 • Behandel de polyester kappen twee keer per jaar met • Als onderdelen beschadigd zijn of ontbreken, moet het auto wax (turtle wax) voor een blijvend mooi oppervlak. product worden losgekoppeld en moeten de onderdelen worden gecorrigeerd, gerepareerd of vervangen om •...
  • Page 71 YA3900-201006...
  • Page 72 Made in the Netherlands YA3900-201006...

Table of Contents