Safety Precautions; Pre-Installation Checklist - Nvidia Mellanox ConnectX-6 Dx User Manual

• Software Stacks - Mellanox OpenFabric software package MLNX_OFED for Linux, WinOF-2 for
Windows, and VMware. See the Driver Installation section.

Safety Precautions


The adapter is being installed in a system that operates with voltages that can be lethal.
Before opening the case of the system, observe the following precautions to avoid injury and
prevent damage to system components.
1. Remove any metallic objects from your hands and wrists.
2. Make sure to use only insulated tools.
3. Verify that the system is powered off and is unplugged.
4. It is strongly recommended to use an ESD strap or other antistatic devices.

Pre-Installation Checklist

1. Unpack the ConnectX-6 Dx adapter card.
Unpack and remove the ConnectX-6 Dx card. Check the parts for visible damage that may have
occurred during shipping. Please note that the cards must be placed on an antistatic surface.

Please note that if the card is removed hastily from the antistatic bag, the plastic
ziplock may harm the EMI fingers on the networking connector. Carefully remove the
card from the antistatic bag to avoid damaging the EMI fingers.
2. Shut down your system if active:
Turn off the power to the system, and disconnect the power cord. Refer to the system
documentation for instructions. Before you install the ConnectX-6 Dx card, make sure that the
system is disconnected from power.
21